ENGINE START/STOP Button

• Changing the Power Mode ENGINE START/STOP Button Operating Range You can start the engine when the smart entry remote is inside the vehicle. The engine may also run if the smart entry r ...

Turn Signals

The turn signals can be used when the ignition switch is in ON . • One-touch turn signal When you lightly push up or down and release the turn signal lever, the exterior turn signals and t ...

See also:

Cylinder Head Inspection for Warpage
1. Remove the cylinder head (see page 6-76). 2. Inspect the camshaft (see page 6-84). 3. Check the cylinder head for warpage. Measure along the edges, and three ways across the center. - If ...

Mode Control Motor Test
'08-09 models with A/T and '10 model with A/T NOTE; Before testing the motor, check for HVAC DTCs (see page 21-9). 1. Disconnect the 7P connector from the mode control motor. Incorrectly app ...

Low Oil Pressure Indicator Circuit Troubleshooting (Open)
1 Connect the Honda Diagnostic System (HDS) to the data Jink connector (DIG) (see step 2 on page 11-3). 2. Turn the ignition switch to ON (ll). 3. Make sure the HDS communicates with the vehicl ...