Honda Accord: Locking/Unlocking the Doors from theInside
• Using the Remote Transmitter
• Locking the doors
Press the lock button.
Once:
uSome exterior lights flash, all the doors lock, and the security system sets.
Twice (within five seconds after the first push):
uA beeper sounds and verifies the security system is set.
If you do not open a door within 30 seconds of unlocking the vehicle with the remote transmitter, the doors will automatically relock.
You can change the relock timer setting.
If the interior light switch is in the door activated position, the interior lights come on when you press the unlock button.
No doors opened: The lights fade out after 30 seconds.
Doors relocked with the remote: The lights go off immediately.
The remote transmitter uses low-power signals, so the operating range may vary depending on the surroundings.
If the distance at which it works varies, the battery is probably low.
If the LED does not come on when you press a button, the battery is dead.
You can customize the door unlock mode setting.
The remote transmitter will not work when the key is in the ignition switch.
The remote transmitter will not work when the key is in the ignition switch.
The remote will not lock the vehicle when a door is open.
• Unlocking the doors
Press the unlock button.
Once:
uSome exterior lights flash twice, and the driver's door unlocks.
Twice:
uThe remaining doors unlock.
• Using the Smart Entry with Push Button Start System*
When you carry the smart entry remote, you can lock/unlock the doors and open the trunk.
You can lock/unlock the doors within a radius of about 32 inches (80 cm) of the outside door handle. You can open the trunk within about 32 inches (80 cm) radius from the trunk release button.
• Do not leave the smart entry remote in the vehicle
when you get out. Carry it with you.
• A person who is not carrying the smart entry
remote can lock/unlock the doors if a person who
is carrying it is within range.
• The door may be unlocked if the door handle is
covered with water in heavy rain or in a car wash if
the smart entry remote is within range.
• If you grip a front door handle wearing gloves, the
door sensor may be slow to respond or may not
respond by unlocking the doors.
• You cannot unlock the door by gripping the handle
after two seconds of unlocking it.
• The door might not open if you pull it immediately
after gripping the door handle. Grip the handle
again and confirm that the door is unlocked before
pulling the handle.
If the distance at which it works varies, the battery is probably low.
If the LED does not come on when you press a button, the battery is dead.
You can customize the door lock mode and keyless lock acknowledgement setting.
• Locking the doors and the trunk
Press the door lock button on the front door.
uSome exterior lights flash; the beeper
sounds; all the doors lock; and the
security system sets.
• Unlocking the doors and the trunk
Grab the driver’s door handle:
uThe driver’s door unlocks.
uSome exterior lights flash twice and the
beeper sounds twice.
Grab the front passenger’s door handle:
uAll the doors unlock.
uSome exterior lights flash twice and the
beeper sounds twice.
Press the trunk release button:
uThe trunk unlocks and opens.
• Even within the 32 inches (80 cm) radius, you may
not be able to lock/unlock the doors with the smart
entry remote if it is above or below the outside
handle.
• The smart entry remote may not operate if it is too
close to the door and door glass.
If you do not open a door within 30 seconds of unlocking the vehicle, the doors will automatically relock.
The light flash, beep and unlock settings can be customized.
• Locking/Unlocking the Doors Using a Key
Fully insert the key and turn it.
iWhen you lock the driver's door with a key, all the other doors lock at the same time. When unlocking, the driver's door unlocks first. Turn the key a second time within a few seconds to unlock the remaining doors.
You can customize the door unlock mode setting.
• Locking a Door Without Using a Key
• Locking the driver's door
Push the lock tab forward 1 or push the master door lock switch in the lock direction 2, and close the door.
• Locking the passenger's doors
Push the lock tab forward and close the door.
• Lockout prevention system
The doors cannot be locked when the key is in the ignition switch*1, or the smart entry remote is inside the vehicle.
When you lock the driver's door, all the other doors lock at the same time.
Make sure you have the key in your hand before locking the door to prevent it from being locked in the vehicle.
Low Smart Entry Remote SignalStrength*
The vehicle transmits radio waves to locate the smart entry remote when locking/ unlocking the doors, opening the trunk, or to start the engine. In the following cases, locking/unlocking the door ...Locking/Unlocking the Doors from the Inside
• Using the Lock Tab • Locking a door Push the lock tab forward. • Unlocking a door Pull the lock tab rearward. When you lock the door using the lock tab on the driver's door, all the o ...See also:
Navigation Communication Line Circuit
Troubleshooting
1. Operate the climate control system in several modes.
Is the climate control system OK?
YES-Go to step 2.
NO-Do the self-diagnostic function with the HDS (see
page 21-102) or climate control ...
CKP Sensor Replacement
1. Raise the vehicle on a lift.
NOTE: Make sure the vehicle is level, because engine
oil will drip out when you remove the sensor.
2. Remove the CKP sensor cover (A).
3. Disconnect the CKP s ...
Rear Bumper Finisher Cover
Replacement
2-door
NOTE:
- Put on gloves to prevent damage.
- Take care not to scratch the rear bumper or the body.
- When prying with a flat-tip screwdriver, wrap it with
protective tape to prevent dama ...