Moonroof Switch Test/Replacement

1. Remove the front Individual map lights (see page 22-258). 2. Disconnect the moonroof switch 12P connector (A) and map light 3P connector (B). 3. Remove the moonroof switch (C) from the map ...

Component Location index

...

See also:

Test/Replacement
EX-L, EX-L PZEV models 1. Remove the cover (A), then disconnect BP connector (B). 2. Turn the ignition switch to ON (II). 3. Measure the voltage between terminal No. 2 and body ground. вР...

Outside Air Temperature Sensor Test
1 Remove the outside air temperature sensor (see page 22-353). 2. Dip the sensor in ice water, and measure the resistance. Then pour warm water on the sensor, and check for a change in resistanc ...

Piston Installation
If the Crankshaft is Already Installed 1. Set the crankshaft to bottom dead center (BDC) for each cylinder as its piston is installed. 2. Remove the connecting rod caps, then install the ring co ...