Changing the Set Speed

You can increase the set cruising speed in any of these ways: Press and hold the RES/ACCEL button. When you reach the desired cruising speed, release the button. Push on the accelerator peda ...

Resuming the Set Speed

When you push the CANCEL button, or tap the brake or clutch pedal, the system will remember the previously set cruising speed. To return to that speed, accelerate to above 25 mph (40 km/h), ...

See also:

VSA Sensor Neutral Position Memorization
NOTE: Do not press the brake pedal during this procedure. 1. Park the vehicle on a flat and level surface, with the steering wheel in the straight ahead position. 2. With the ignition switch i ...

Under-floorTWC Removal/Installation
1. Raise the vehicle on a lift. 2. Remove the exhaust pipe hangers (A). 3. Remove the under-floor TWC (B). 4. Install the parts in the reverse order of removal with new gaskets (C) and new s ...

Brake Fluid
The fluid level should be between theMINandMAXmarks on the side of the reservoir. If the level is at or below the MIN mark, your brake system needs attention. Have the brake system inspect ...