Honda Accord: Rear Inner Fender Replacement - Fenderwell - Body - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Rear Inner Fender Replacement

NOTE: Take care not to scratch the rear bumper or the body.

1. Remove the screws, then remove the rear inner fender (A) from the rear bumper (B) and the body.

2. Install the inner fender in the reverse order of


2. Install the inner fender in the reverse order of removal.

    Fuel Pipe Protector Replacement
    NOTE: - Put on gloves to protect your hands. - Take care not to scratch the body. - When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage. 1. Remove the le ...

    Rear Air Outlet Replacement
    NOTE: Take care not to scratch the body. 1_ Remove the rear bumper (see page 20-260). 2. Release the hooks (A), then remove the rear air outlet (B). 3. Install the air outlet by pushing on t ...

    See also:

    Instrument Panel
    This chapter describes the buttons, indicators, and gauges that are used while driving. ...

    Reverse Idler Gear Removal and Installation
    Removal 1. Remove the bolt (A) securing the reverse idler gear shaft holder (B). 2. Install a 5 x 0.8 mm bolt (C) in the reverse idler gear shaft (D), and pull it to remove the reverse idler gea ...

    DTC Troubleshooting
    DTC P0420: Catalyst System Efficiency Below Threshold NOTE: - Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see pa ...