Motor Test

1. Remove the front seat back panel, and seat-back cover/pad. • 4-door (see page 20-221) • 2-door (see page 20-213) 2. Disconnect the 2P connector (A) from the lumbar support motor (B ...

Component Location Index

...

See also:

Your Vehicle at a Glance
Your Vehicle at a Glance Your Vehicle at a Glance ...

Backlash Inspection
1. Place the differential assembly on V-blocks (A), and install the intermediate shaft (B) and the left driveshaft (C). 2. Measure the backlash of both pinion gears (D) with a dial indicator (E) ...

A/T Clutch Pressure Control Solenoid Valve B and C Test
1. Connect the HDS to the DLC (A) located under the driver's side of the dashboard. 2. Turn the ignition switch to ON (II). Make sure the HDS communicates with the PCM. If it does not, go to the ...