Honda Accord: Security Hood Switch Test
1. Open the hood.
2. Disconnect the 2P connector from the security hood switch.
3. Check for continuity between the terminals.
• There should be continuity between terminals No. 1 and No. 2 when the hood is opened (latch released).
• There should be no continuity between terminals No. 1 and No. 2 when the hood is closed (latch pushed down).
4. If the continuity is not as specified, replace the hood latch assembly (see page 20-302).
Door Key Cylinder Switch Test
1. Remove the driver's door panel (see page 20-17).
2. Disconnect the 10P connector (A) from the door lock
actuator (key cylinder switch) (B).
3. Check for continuity between the terminals.
...
Trunk Lid Release Actuator Test
With Keyless Entry
1. Open the trunk lid.
2. Disconnect 3P connector f r om the trunk lid latch
switch/trunk release actuator.
3. Check actuator operation by connecting power to
terminal No. ...
See also:
Replacing Tires andWheels
Replace your tires with radial tires of
the same size, load range, speed
rating, and maximum cold tire
pressure rating (as shown on the
tire’s sidewall).
Mixing radial and bias-ply tires on ...
Audio-HVAC Display Unit
Removal/Installation
Without Navigation
NOTE;
• Put on gloves to protect your hands.
• Take care not to scratch the dashboard.
1. Remove the audio unit (see page 23-114) and the
center display visor (se ...
Mainshaft Inspection
1. Inspect the gear and bearing contact areas for wear
and damage, then measure the mainshaft at points A,
B, C, D, and E. If any part of the mainshaft is less than
the service limit, replace it.
...