Honda Accord: To Stop Playing a Disc
Press the eject button ( ) to
remove the disc. If you eject the disc,
but do not remove it from the slot,
the system will automatically reload
the disc after 10 seconds and begin
playing.
You can also eject the disc when the ignition switch is off.
To play the radio when a disc is playing, press the AM, FMor XM (if equipped) button. Press the CD (CD/AUX on models with XM Radio) button again to switch back to the disc changer.
You can also press the MODE button on the steering wheel to change modes.
If you turn the system off while a disc is playing, either with the power/volume knob or by turning off the ignition switch, the disc will stay in the drive.When you turn the system back on, the disc will begin playing where it left off.
Removing Discs from the In-dash Disc Changer
To remove the disc currently in play, press the eject button. When a disc is removed from a slot, the system automatically begins the load sequence so you can load another disc in that position. If you do not remove the disc from the changer within 10 seconds, the disc will reload into the slot. Then the system returns to the previous mode (AM, FM, or XM Radio).
To remove a different disc from the changer, first select it with the appropriate preset button. When that disc begins playing, press the eject button. Continue pressing the eject button to remove all the discs from the changer.
You can also eject discs when the ignition switch is off. The disc that was last selected is ejected first.
To Play a Disc
To load or play discs, the ignition
switch must be in the ACCESSORY
(I) or ON (II) position.
You operate the disc changer with
the same controls used for the radio.
To select the disc changer, ...
Protecting Discs
For information on how to handle
and protect compact discs. ...
See also:
To Stop Playing Your iPod
To play the radio, press the AM, FM,
or button. Press the CD/
AUX button to switch between disc
mode (if a disc is loaded) and the
iPod and AUX. On models without
XM Radio, press the CD but ...
Combination Light Switch
Test/Replacement
1. Remove the driver's dashboard lower cover (see page 20-166).
2. Remove the steering column covers (see page 17-10).
3. Disconnect the 12P connector (A) from the combination light switch (B).
...
Seat Heater Test
Driver's Seat
1. Remove the driver's seat (see page 20-194).
2. Remove the seat back panel.
• 4-door (see page 20-221)
• 2-door (see page 20-213)
3. Disconnect the connector A (4P) ...