Windshield Washers

Check the level in the windshield washer reservoir at least monthly during normal use. Check the fluid level by removing the cap and looking at the level gauge. On Canadian models: The low ...

Automatic Transmission

Check the fluid level with the engine at normal operating temperature. 1. Park the vehicle on level ground. Start the engine, let it run until the radiator fan comes on, then shut off the en ...

See also:

Drive Belt Inspection
1. Inspect the belt for cracks or damage. If the belt is cracked or damaged, replace it (see page 4-30). 2. Check the position of the auto-tensioner indicator's pointer (A) is within the standard ...

Outside Air Temperature Sensor Replacement
1 Disconnect the 2P connector (A) from the outside air temperature sensor (B). 2. Lift the tab (C) to release the lock, then remove the outside air temperature sensor from the front bumper. 3 ...

Warm Up TWC Removal/Installation
1. Raise the vehicle on a lift. 2. Remove the secondary H02S (Sensor 2) (see page 11-197). 3. Remove the bolts (A). 4. Remove the WU-TWC bracket (B). 5. Lower the vehicle. 6. Remove th ...