Ignition System

...

Ignition Timing Inspection

1. Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) (see step 2 on page 11-3). 2. Turn the ignition switch to ON (II). 3. Make sure the HDS communicates with the vehic ...

See also:

Circuit Diagram
DRIVER'S UNDER-DASH FUSE/RELAY BOX CONNECTOR P (20P) BRAKE PEDAL POSITION SWITCH 4P CONNECTOR GAUGE CONTROL MODULE 32P CONNECTOR VSA OFF SWITCH BP CONNECTOR YAW RATE-LATERAL ACCELE ...

Immobilizer-Keyless Control Unit Replacement
1 . Remove the driver's dashboard lower cover (see page 20-166). 2. Remove the steering column covers (see page 20-181). 3. Disconnect the 7P connector (A) from the immobilizer-keyless contro ...

Throttle Body Cleaning
Do n o t i n s e r t : your fingers into the installed throve body when you turn the ignition switch to ON (II) or while the ignition switch is in ON (II). If you do, you will seriously injure your ...